Bashbar e36 install#
Install the Pump Feed Adapter onto the inlet hole of the pump, then use the stock bolts to attach the bracket portion to the pump from the OE mounting location of the pre-existing barb. The Chase Bays Pump Feed Adapter comes with a fitting and o-ring - place the fitting onto the pump sealing surface with the provided o-ring on the surface groove. We do not provide this, as we always recommend switching to a non HICAS pump for RB Power Steering Kits. If you have a HICAS pump, you can de-power the rear section of pump and block off the inlet. Remove bolts holding on the barb adapter and the o-ring located beneath it. This is a huge advantage for lowered track cars and it means. This bash bar also features a center jacking point to allow for easier servicing. Our front bash car is designed to fit all E36 chassis and will tuck away under an M3 bumper for that stealth look. If you have a Power Steering Cooler version of any of these Power Steering Kits, scroll to the bottom of the page for that portion of your installation!īefore installing any portion of the kit, we will start by removing the factory Pump Feed Adapter from the OE Power Steering Pump. BMW E36 Front Bash Bar The E36 has become an increasingly popular chassis for drifting and we're here to support this growing community.
Power Steering Kit Installation Instructions: It is always wise to test fit lines 100% before drilling holes/installing rivnuts for mounting. Then mount the bracket to the area behind the headlight using self-sourced hardware. Included in the threaded holes of the Reservoir, use the 2x M8 bolts to attach the Reservoir to the Mounting Bracket. Use the supplied Reservoir and Type 3 Mounting Bracket to mount to the front corner of the engine bay, behind the core support on the side of the engine bay that the PS Pump is installed to.
0 kommentar(er)
